SW-MOTECH Handlebar Riser 22mm Up and Back

SW-MOTECH Handlebar Riser 22mm Up and Back Provides a more upright, comfortable riding position by raising and retracting the original 22 mm diameter tubular handlebar. No need to replace your handlebars – simply remove the original top clamp, place the riser between the handlebar and original bottom clamp, and install the replacement top clamp using included hardware. Barbacks increase handlebar height by 30mm and move them back 21mm , producing an overall handlebar displacement of 35.4mm at a 45 degree angle from the original position. When installed, there may be a slight gap between the bar riser and the top clamp. This gap allows the top clamps to be torque-tightened onto the bar riser to prevent the bar from spinning. No change of control cables, wiring, or hoses is required for most motorcycle models. HOWEVER: Barbacks offer significant additional displacement of the handlebars and are more likely to require modification of cable/wiring/hose slack after installation than are standard handlebar risers. The installer should always check for adequate cable/wiring/hose slack after installing any handlebar riser. SW-MOTECH Handlebar Riser 22mm Up and Back Raises 30 mm and relocates the bar 21 mm back. Fits motorcycles with 22 mm handlebar and 32 mm – 38 mm hole seperation. Optimises the sitting position. Made of extremely firm aluminium alloy. Silver powder-coated. Included: Barback. Mounting material. Mounting instructions. Features: Including cover. The length of bowden cables has to be checked individually. Find out more info on these and other products in our range of Handlebar risers here.